查询词典 maximum element

The author also studies the relationship between the maximum friction coefficient, optimum slip ratio, friction coefficent with locked wheels and three parameters in friction coefficient function of slip ratio, and three fit functions derived from experimental analysis, maximum friction coeffient, optimum slip ratio and friction coefficent v~ ith locked wheels, of aircraft speed.

利用试验数据研究了最佳滑移率、结合系数最大值和机轮抱死时的结合系数随飞机速度的变化规律。两者联系在一起，便得到了结合系数随飞机速度和滑移率的变化规律。它是本文的创新点之三。

The net photosynthetic rate and maximum net photosynthetic rate of slash pine's half-sib around 1 year is studied utilities of LI-6400 portable photosynthetic system so as to study on the seasonal variation and difference on net photosynthetic rate. The result showed that the seasonal variation of net photosynthetic rate and maximum net photosynthetic rate of slash pine's half-sib is double range curve. There is no notable difference on net photosynthetic rate among needles with same half-sib. There is notable difference on net photosynthetic rate with same needles among half-sib. The net photosynthetic rate of 1 year needle of half-sib 464 and 609 and 1077 is over than others.

为研究湿地松半同胞家系间净光合速率的差异及其季节变异规律，应用LI－6400便携式光合测定系统，对湿地松优良半同胞家系一年中各月净光合速率、最大净光合速率进行了研究，结果表明一年中湿地松各半同胞家系1龄针叶、2龄针叶净光合速率、最大净光合速率的季节变异规律呈'双峰'型，家系内不同单株同龄针叶的净光合速率值没有显著差异，而家系间相同年龄针叶的净光合速率值则存在着显著差异。

The analysis shows that, blade vibration and torsional deformation is the mainly manifestations of the cutting mechanism head body ,the maximum deformation of the helical blade is 18.01mm, the maximum stress value in the welding of corner ,connection of end disk and helical blade is the weak link, helical blade is the main component, which effects the dynamic characteristics of cutting mechanism head body.

所得结论对于改进螺旋钻采煤机截割机构头体的设计、提高其动态性能和使用寿命具有一定的指导意义和参考价值。2、文章中部分措词需要修改，摘要翻译中文化，论文整体格式需要修改。3、数值模拟的约束条件有待商榷，对于结果应该对比实际试验和有关材料特性表，更有说服力。

The results of DDME1 and TW99 have little odds, they both give the stronger meson field potential, the smaller hyperon transition density, the harder equation of state and the bigger maximum mass; opposite to DDME1 and TW99, the GL97, TM1 and GL85 give the weaker meson field potential, the bigger hyperon transition density, the softer equation of state and the smaller maximum mass.

其中DDME1和TW99计算的结果基本相同，它们给出较强的介子场势、较小的超子转变密度、较硬的物态方程和较大的质量极限；而GL97、 TM1和GL85

The maximum ice storage line showsthe maximum level in the case where ice cubes are made evenly in the ice case. If

最大储冰位置标准线表示的是冰块平放在冰盒中时的最大容量。

This analytical approach shows that, as increasing the wear flat of indenter, the maximum indentation force needed to develop critical plastic zone increases and its corresponding critical penetration depth also increases slightly, Note that the effect of wear flat will affect rock fracture behavior. In addition, regarding the simulation of the effect of doubled-indenters, result shows that two adjacent indenters may interact each other as reaching the transient/critical relative space between indenters of 2~3. It dicpicts that a proper spacing arrangement between indenters may enhance a efficient mechanical cutting due to the less required maximum indentation force and energy dissipation.

由数值模拟之结果得知，当楔尖磨耗增加时，岩材产生脆性破坏之初裂贯切力随之增加，而其对应之临界贯入深度则亦微幅增加，故磨耗效应确会干扰岩材脆性破坏机制之形成；而由双刀效应之模拟，可知两贯切刀楔互制影响之破坏裂缝生、衍行为，当双刀相对刀距为时，岩材之破坏特徵有明显变化，即定义此为临界相对刀距，并探讨其产生脆性破坏所需初裂贯切力之变动范围及应力重叠区，由此得知适当之刀距安排将有助於减少能量之耗损。

This thesis focuses on maximum-power-point-tracking algorithm applying for wind-turbine generator system. The system includes the serve-motor, induction generator, three-phase full bridge rectifier, buck converter and fixed load. This thesis uses traditional Current Perturbation Algorithm as well as Perturbation Stochastic Approximation Algorithm to implemented with Matlab/simlink and hardware to achieve the maximum power tracking.

本文针对风力发电系统提出最大功率追踪法则，整体系统架构包含了伺服马达、感应发电机、三相全桥式整流器、降压直流转换器和固定负载，并由传统电流型扰动观察法合并扰动近似演算法，进行Matlab/simlink 模拟与电路实作设计来完成最大功率追踪。

The law was alike between initial stage and the peak of growth, but the rates reaching maximum of negative and positive were in the different soil depths , and the inflexions of increment anti decrement by degrees were also different. The soil water content in terminal stage increased positively, and in surface reached the maximum, but decreased with the depths, except a little increment in the depth of 460~600cm.

年生长季内，不同生长时期，土壤含水量变化的速度不同，生长初期和生长旺季的规律相似，但速度出现负的最大和正的最大所在的土层深度不同，速度递增和递减所在的土层深度也不同，生长末期速度均为正值，表层最大，随土层深度的加深，速度递减，但到460~600 cm处速度略有增加。

This involves a combination of maximum ingroup profit and maximum difference?

有所偏袒？这包含了最大本组利益和最大两组间差距的结合。

This involves a combination of maximum ingroup profit and maximum difference?

有所偏袒？这包含了最大本组利益和最大两组差距的结合。

When this condition occurs, inbound replication with the source partner is stopped on the destination domain controller and event ID 2042 is logged in the Directory Services event log.

计算机密码学是研究计算机信息加密、解密及其变换的科学，是数学和计算机的交义学科，也是一门新兴的学科。

Instructions: click on the thumbnails to see a larger image, then use the left-right arrow keys to scroll through the slideshow.

使用说明：滑鼠点在小图上即可放大观赏。开启后键盘左右键可用来换照片。