查询词典 electrode effect

By means of electric potential method and anodic stripping voltammetry , the trace Cd~(2+) in the soil samples of rich iron content can be determined by a 883—model polarograph, with the mercury membrane electrode of silver base sphericity as the indicating electrode and a large area of sheet—silver electrode as the reference electrode.

本文应用电位法，采用银基球型汞膜电极为指示电极，大面积银片电极为参比电极和883型极谱仪，阳极溶出法测定大量铁存在下的土壤样品中痕量镉。

The current density peak of brass welded line appeared at -0.012 V, and a porous corrosion film was formed. The electrode was passivated subsequently. The passivation film was made up of Cu2O, CuCl and ZnO. The passivation film dissolved with electrode potential, and displacement deposition took place between Cu and Zn. The copper redeposition on the electrode surface induced the increase of electrode activity and corrosion rate.

黄铜焊缝在电位-0.012V时出现电流峰，腐蚀产物膜多孔、疏松，随后电极进入钝化区，钝化膜由Cu2O、CuCl和ZnO组成；随电位升高，钝化膜溶解，发生铜锌置换反应，沉积的Cu导致活性电对的形成，增加了合金的腐蚀速度；当电位为+0.87V时，电极表面富集了针状锡和锡的氧化物。

We studied trivalence chromium ion electrode reaction on three different surface state by cyclic voltammetry, discussed electrode activation influence on electrode reaction, and analysed the mechanism of electrode reaction. We discussed current efficiency during the first charge process and charge/discharge cycle performance by invariable current charge method.

应用循环伏安法考察了三价铬离子在三种不同表面状态石墨电极上的电极反应，探讨了电极表面活化处理对三价铬离子的电极反应的影响，并分析了电极反应的机理；采用恒电流充电的方法探讨铬液流电池初次充电过程的电流效率及恒电流充/放电循环的性能。

Said film made electrode has good charge discharge circulation reversibility, wherein: copper diselenide film made electrode specific capacity keeping on 220 mah/g; copper selenide film made electrode specific capacity keeping on 160 mah/g; cuprous selenide film made electrode specific capacity keeping on 210 mah/g more or less.

由这三种薄膜制成的电极，都具有良好的充放电循环可逆性，其中：由二硒化铜薄膜制成的电极的比容量保持在220mAh/g左右；由硒化铜薄膜制成的电极的比容量保持在160mAh/g左右；由硒化亚铜薄膜制成的电极的比容量保持在210mAh/g左右。

The results show that spheriform electrode degradation mechanism was basically caused by wear due to fracture of local welding between the electrode tip surface and zinc coated sheet steel happen at electrode surface and alloying between electrode and zinc on zinc coated steel during resistance spot welding zinc coated steel.

结果表明：点焊镀锌钢板时，球形电极的失效机制，主要是电极和镀锌板之间局部焊接的断裂发生在电极表面而导致的电极磨损，以及电极和镀锌板表面的锌之间的合金化。

Butt Weld and docking and corner combinations Weld, in Weld ends located arc plate and extraction plate in igniting board then leads to the welding seam, joint halfway shall weld joints in front of 2.0 mm Department Firing arc, welding pieces after preheating rod will return to weld the origin, pool filled to the required thickness, before forward welding; Welding speed : Isokinetic welding requirements to ensure weld thickness, width uniform, which masks to look for hot metal and slag bath equidistance (2-3 mm)%; Arc welding rod length : different models and determined that the general requirements of arc length is stable, acid electrode generally 3-4 mm, 2-3 mm normally alkaline electrode%; Welding perspective : According to determine the thickness of two pieces of welding, welding angle has two aspects : First, the angle between the direction of the rod and welding of 60-75 ; The second is the angle between two electrodes and welding around, the same thickness as welding, welding and welding pieces incident angle of 45 ; When the thickness ranging from welding, welding electrode and thick and thin pieces of welding electrode side angle greater than the angle between the side pieces; Arc : admission to the end of each weld should be filled crater, in the direction opposite to the direction of the back-arc welding, arc welding unchanged inside pit in 1974, to prevent the crater bite of meat.

对接焊缝及对接和角接组合焊缝，在焊缝两端设引弧板和引出板，必须在引弧板上引出后再焊到焊缝区，中途接头则应在焊缝接头前方15～20㎜处打火引弧，将焊件预热后再将焊条退回到焊缝起始处，把熔池填满到要求的厚度后，方可向前施焊；焊接速度：要求等速焊接，保证焊缝厚度、宽度均匀一致，从面罩内看熔池中铁水与熔渣保持等距离（2～3㎜）为宜；焊接电弧长度：根据焊条型号不同而确定，一般要求电弧长度稳定不变，酸性焊条一般为3～4㎜，碱性焊条一般为2～3㎜为宜；焊接角度：根据两焊件的厚度确定，焊接角度有两个方面，一是焊条与焊接前进方向的夹角为60～75 ；二是焊条与焊接左右夹角有两种情况，当焊件厚度相等时，焊件与焊件夹角为45 ；当焊件厚度不等时，焊条与较厚焊件一侧夹角应大于焊条与薄焊件一侧夹角；收弧：每条焊缝焊到末尾，应将弧坑填满后，往焊接方向相反的方向带弧，使弧坑甩在焊道貌岸然里边，以防弧坑咬肉。

Results show that the servic.e life of TiB2/Cu electrode with a TiB2 content of 1.5 wt% reaches 7700 weld spots, which is 4 to 8 times that of Cr-Zr-Cu electrode materials when coated steel sheets are spot welded; the service life of the composite electrode reaches 30000 weld spots, 2 to 3 times that of Cr-Zr-Cu electrode materials when conventional carbon steel sheets are spot welded.

对 T i B2增强铜基复合材料作点焊电极点焊镀层钢板时的失效进行了分析，结果表明：含TiB2为1.5wt％的铜基复合材料作电极，焊接镀锌钢板的使用寿命约为7700点，是普通电极材料Cr－Zr－Cu的4～8倍，焊接普通钢板的使用寿命约为30000点，是普通电极材料Cr－Zr－Cu的2～3倍。

At the same time, sales of wear resistant welding rod, cast iron welding rod, stainless steel welding rod, casting tungsten carbide welding rod, low carbon steel welding rod, factory products:úspecial wear-resistant electrode, Sham Tseng bit special wear-resistant electrode, with wear-resistant welding rod mill, cement brick special wear-resistant electrode, pears seeder cultivator blades and other special wear-resistant electrode, the above Domestic Product of several ministerial-level enterprise year-round use.

同时销售耐磨焊条、铸铁焊条、不锈钢焊条、铸造碳化钨焊条、低碳钢焊条，本厂拳头产品：木炭机专用耐磨焊条、深井钻头专用耐磨焊条、粉碎机用耐磨焊条、砖瓦厂水泥厂专用耐磨焊条、播种机旋耕梨刀片专用耐磨焊条等，以上产品数家国内厅部级企业常年使用。

At Hcy/Au electrode, there were electrocatalytic responses of DA and E with ΔEp 57.5mV and 63.5mV, respectively. The standard rate constants k〓 were calculated as 2.1×10〓 cm s〓 and 1.6×10〓 cm s〓 corresponding to DA and E. The electron transfer number n〓=1 was achieved, which revealed that the 2e transfer of DA and E is not completed by one step at the electrode. Because AA also displayed electrocatalytic behavior at Hcy/Au electrode, DA and E can be determined in presence of AA.At Hcy/Au electrode, a pair of very stable and well-defined redox waves of Mb were obtained.

在Hcy/Au电极上分别得到多巴胺、肾上腺素的一对可逆的氧化还原波，求出两者的电极反应速率常数分别为2.2×10〓cm s〓和1.6×10〓cm s〓，推导出在两者的电极反应过程中均存在一个自由基并且它的形成决定了整个电极反应的速度；由于抗坏血酸在此电极上也具有电催化响应，可以在抗坏血酸存在下对多巴胺和肾上腺素进行测定。

The aqueous phase containing a redox couple is supported on the surface of platinum electrode, then the electrode is inverted and immersed into the organic phase along with reference and counter electrode to construct a classical three-electrode system.

将含有氧化还原电对的水相支撑在铂盘电极表面，倒置后插入到有机相中，与参比电极和对电极构成常规的三电极系统，实现了液/液界面上的电荷转移反应。

Chinese traditional virtue is humility and wariness,the compliment and praise to the others should be declination

中国人的传统美德是谦虚谨慎，对别人的恭维和夸奖应是推辞。如

We bought this house on the never-never.

我们以分期付款的方式买下这座房子。