查询词典 detecting

Based on the function characteristic of carbon fiberreinforced concrete, a nondestructive method for detecting the damage in CFRC by using infrared thermograph, is presented.

本文利用碳纤维机敏混凝土的功能特性，采用红外热像无损检测方法检测机敏混凝土构件中的裂纹损伤。

Previously we use some impotents like thermograph detecting the temperature, but with the development of science and technology, the old means can not satisfy our needs, because the average thermograph must directly contact the measured substances, we must design some test equipments, which can measure the temperature without contacting the measured substances.

从前我们测温，用温度计等一些器具，但是随着科技的发展，这是远远不够的，因为普通的温度计必须直接接触被测物体，所以我们现在就要设计一些可以不接触被测物体就能得出其温度值的测试仪。

An experiment of detecting the simulated damage of a concrete beam by the infrared thermography is carried out.

在此基础上，发展了一类修正后的局部方差对比的融合规则。

Electron paramagnetic tesonance and thermoluminescence are effective methods for detecting electron and hole centers.

电子顺磁共振波谱和热发光是检测石英中电子-空穴心的有效方法。

Heating billet temperature cannot be detected in the hearth. Only by detecting temperatures of the stove side or hearth with estimation from mere experience could lead to great error on the measurement of billet temperature and affect the quality of post-processing accordingly; Overheating also exists in the heating process, and the quality of product is sway by overheating oxidation. Though infrared thermoscope is used to detect the temperature of billet when it is taken out of the stove, precision is still affected because of the oxide layer on the surface.

燃气与空气的配气量比例，一般通过人工调节，未实现按加热条件自动动态调节；无法在炉膛内检测被加热钢材的温度，只能通过检测炉壁或炉膛温度，再凭经验估计钢材温度，结果是钢板温度误差大，影响后续加工质量；钢材加热存在表面过烧现象，有时表面烧损、氧化严重，影响产品质量；尽管钢材出炉时，可用红外线测温仪来进行钢材表面温度检测，但因钢材表面存在氧化层，也影响钢材温度检测精度。

This project was established based on the first cooperative development of optical in situ real time detecting technique probing the atomic scale layer-by-layer epitaxy growth of oxide film. Over the last three years, we have given full play to the advantages and characteristics of both sides and have finished the assumptions and plans of this subject satisfactorily. 1. In Institute of Physics, we set up advanced oblique-incidence reflectivity difference equipment and wrote one data acquisition procedure that made the simultaneous detection of optical signal and RHEED signal into reality. 2. The first observation of sustained oscillations over hundreds of monolayers in both real and imaginary signals during the epitaxy growth of SrNb0.1Ti0.9O3 on SrTiO3 substrate in LMBE testifies that oblique-incidence is an excellent method to detect and monitor film epitaxy growth real time. 3. For the first time, we verify that oblique-incidence reflectivity difference method can be used to monitor the layer-by-layer growth mode during continuous growth through the correspondence between optical signals to atomic or molecular step edge density on the growth surface. 4. Phenomenological analysis shows that optical signals comprise three parts, the first is proportional to the average thickness of the film and depends on the bulk phase dielectric response; the second is proportional to the coverage of terraces and depends on the dielectric response of atoms or unit cells in the terrace; the third is proportional to the coverage of step edges and depends on the effective dielectric response of atoms or unit cells at step edges. This makes oblique-incident reflectivity difference technique a quantitative macroscopic method to monitor film growth.

中文摘要：本课题是在合作首次发展了氧化物薄膜原子尺度层状外延生长光学原位实时探测方法的基础上立项的，三年来，我们充分发挥双方的优势和特点，圆满完成了课题的设想和计划。1、在物理所建立了一套先进的光反射差法装置，编写了计算机系统的数据采集程序，实现了两路光学信号和RHEED数据的同步采集和显示。2、用激光分子束外延在SrTiO3基底上生长SrNb0.1Ti0.9O3薄膜，首次观测到连续外延几百个原胞层，周期振荡的光反射差实部和虚部信号，证明了光反射差法是一种能原位实时探测与监控薄膜层状外延生长的好方法。3、首次验证了通过对生长表面原子或分子台阶密度的响应，光反射差法可用于原位实时监测在连续生长条件下薄膜的层式生长模式。4、通过唯象理论的研究，证明光反射差信号由三项组成，第一项只与薄膜的平均厚度和宏观光学电介质常数有关；第二项与分子台阶面覆盖度和台阶面上分子层的光学电介质常数有关；第三项与台阶边缘的覆盖度成正比，并和在台阶边缘的分子的有效光学介电常数有关。

Automatic threshold choice is difficult and important to color images edge detection, First of all, on the base of human visual properties, threshold versus intensity function of human visual system are researched and analyzed, by using method of mathematic modeling and the result of saturation research, function of least color difference that can be perceptible by visual systems in detecting edge is given.

摘要自动阀值选取是彩色图像边缘检测的难点和关键问题，首先从人类的视觉特性出发，分析了人类视觉系统的亮度感知门限函数，利用数学建模方法和色度学方面的研究成果，给出人类视觉系统对彩色图像边缘所能识别的最小彩色差函数。

Objective: To explore clinical significance of detecting prothrombin time, the activated partial thromboplastin time, thrombln time, plasma fibrinogen for parturient women.

目的；探讨检测临产孕妇凝血酶原时间、活化部分凝血活酶时间、凝血酶时间、纤维蛋白原的临床意义。

Detecting serum AchRab and CAEab after thymectomy may assist to judge patient?s condition.

手术后血清AchRab和CAEab的检测有助于了解患者的病情。

The socket structure is provided with a zero phase trigger control unit, through the photoelectric sensing element of the unit, optical coupling can be performed to generate zero phase trigger, and the opening or the closing of a two-way thyratron in the zero phase can be accurately controlled, therefore, an electric device inserted on an output socket can be started or stopped from the zero phase, in order to reduce the electromagnetic interference and prolong the service life of the electric device, the use efficiency of the electric device can be enhanced, the power supply thereof can be saved, filtering and rectifying can be performed through a current switching unit when the alternating current power supply passes through a filtering and rectifying circuit, the noise caused by external interference and affect can be filtered, and the power supply can be respectively transmitted to a current detecting socket and the input end of the current switching unit to be detected through a temperature sensor arranged on the current switching unit.

本实用新型为有关一种插座结构，尤指为设有零相位触发控制单元，可通过其光电感测元件来进行光耦合而产生零相位的触发，且可准确控制双向闸流阀在零相位的开启或者关闭，进而达到插置于输出插座上的电器装置从零相位开始启动或者关闭，以降低电磁干扰而延长电器装置使用寿命，且可提升电器装置的使用效率及节省电源，并通过电流转换单元于交流电源通过滤波整流电路进行滤波整流，可滤除外部所干扰影响的杂讯，并分别传送至电流侦测插座及电流转换单元的输入端，而可通过电流转换单元所设置的温度感应器来进行侦测，于电路温度升高时，温度感应器可进行切断双向闸流阀的电源输出而达到保护输出插座上所插设的电器设备。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。