查询词典 byte

Note that alignment to 4096-byte boundaries is a PharLap extension to the format and may not be supported by all linkers.

注意，对齐到4096字节的边界是这种格式的PharLap扩展，并不是所有的连接器都支持。

Little-endian The most significant byte is on the right end of a word.

比如我有1234元人民币，最值钱的是1000元，最不值钱的是4元，那么这个1就是最重要的字节

Next comes second parameter's definition, because the second argument is single dimensional and zero-based array, this four bytes specifies the number of elements supplied to the array of the second parameter, this value is stored as an unsigned int32 in little-endian byte order.

接下来是第二个参数的定义，因为第二个参数是一维和零的数组，这4个字节指定提供给第二个参数数组元素的数量，此值是作为一个小符号int32储值endian字节顺序。

If more than a few megabytes big operation, it is high byte storage order of priority.

如果操作数比一个字节大，那么它存储的顺序是高位字节优先。

In addition, the scratchpad provides access to the 1-byte upper and lower alarm trigger registers.

此外，暂存器可以访问的1个字节的上限和下限报警触发寄存器。

Thus the full 64-byte capacity of the scratchpad is available, resulting also in the ending offset of 3Fh.

因此，完整的64字节暂存器容量可用，造成在结束3Fh也抵消。

The lower six bits of the E/S register indicate the address of the last byte that has been written to the scratchpad.

6位较低的E / S寄存器指示的最后一个字节，已写入暂存器的地址。

The scratchpad memory contains the 2-byte temperature register that stores the digital output from the temperature sensor.

暂存器记忆体包含2个字节的温度寄存器，储存来自温度传感器的数字输出。

Following the conversion, the resulting thermal data is stored in the 2-byte temperature register in the scratchpad memory and the MB81C79A-45 returns to its idle state.

转换后，所产生的热数据存储在内存中的暂存和MB81C79A - 45返回其空闲状态2字节温度寄存器。

If the target address (TA1) for a Write command is 103Ch for example, then the scratchpad will store incoming data beginning at the byte offset 3Ch and will be full after only four bytes.

如果目标地址（TA1是否为写命令）可以例如103Ch，然后将存储在暂存器字节偏移3通道开始输入数据后，将只有4个字节爆满。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。